Problems? with Information display: temperature
Willem Ferguson
willemferguson at zoology.up.ac.za
Tue Oct 15 12:53:44 UTC 2013
I hate to do this to you, having just read of Dirk's intention to
release V4 before the end of the year. I hope it is something I do not
understand.
When I move my mouse over the profile, the information box normally
displays the following:
Depth
Time
Pressure
Vertical speed
Nodeco limit
PO2
See image at: https://www.dropbox.com/s/lqsua8wfe23fxwy/Info2.png
However, every once so often, when there is a change in temperature,
there is a Temp line between Pressure and Volume.
See image at: https://www.dropbox.com/s/r9rilpvbfxfa9qh/Info1.png
It seems that it sees a change in temp, shows it in Information box, but
immediately forgets the temperature until it registers a new change in
Temp. I suspect this is not the way temperature display was intended in
the Info box.
IMPORTANT: As an aside, both Time and Temp are indicated with a T in the
Info box, potentially confusing. What about making temperature 'Tmp'? I
cannot see the temperature string exceeding the vertical speed
(immediately below) string in length if one did this, thus not affecting
the size of the Information box.
I apologise for just adding to your work, and thank you very much for
your work.
Kind regards,
Willemf
More information about the subsurface
mailing list