Subsurface should display reason for red background in Planner

[Dirk Hohndel]

On Fri, Jul 11, 2014 at 04:11:56PM +0200, Joakim Bygdell wrote:
> On 11 Jul 2014 16:04, "Dirk Hohndel" <dirk at hohndel.org> wrote:
> >
> > On Fri, Jul 11, 2014 at 09:38:12AM +0200, Joakim Bygdell wrote:
> > > If I recall correctly the red overlay was to show that something in the
> > > planned dive where wrong, breach of ceiling, out gas, breach of ppO2
> limit
> > > and so on.
> >
> > I believe breach of pO₂ is only mentioned in the notes, not in the
> > profile, same for using more gas than is in your cylinders. The only time
> > the profile goes red is if one of the manually entered profile points ends
> > up below your ceiling...
> 
> Something that should not happen if you only feed the planner depth and
> time for the bottom phase. Even if you shift between last stop at 3 or 6
> m.

Definitely. That needs to be debugged.

/D