Poseidon CSV import
Willem Ferguson
willemferguson at zoology.up.ac.za
Thu Nov 13 11:09:28 PST 2014
Miika,
There is a small problem in the Poseidon CSV import. It is evident not
while doing a CSV import, but when exporting the dive to xml. I
understand the cause but not the solution. In the CSV import, cylinder
start and end pressures are stored in cyl->sample_start and
cyl->sample_end. When writing to xml, the start and end pressures for
cylinder 0 (oxygen), have not been transfered to cyl->start and
cyl->end: these latter values are both zero and are used for writing to
xml. Consequently the start and end pressures of the oxygen cylinder are
not written to xml. For the diluent cylinder everything is ok, the
pressures have been transfered for cyl->sample_start and sample_end to
cyl->start and cyl->end.
Probably half of my dives are multi-cylinder, and when reading my
divelog with multiple cylinders from xml, the cyl->start and cyl->end
values are always set up correctly for all cylinders. I have spent quite
a bit of time looking around for a solution, but have only found a
workaround or two, not a solution. Do you have any ideas?
Kind regards,
willem
More information about the subsurface
mailing list