[PATCH] Remove leftover bits between sensors and setpoint

[Anton Lundin]

On 13 September, 2015 - Anton Lundin wrote:

> This removes leftover bits from when setpoint and sensor values where
> treated the same way.
> 

I was/still are to tired to write good commit messages.

Here comes some explanation.

Previously subsurface treated DC_SAMPLE_SETPOINT and DC_SAMPLE_PPO2 the
same way.

Back in "Store DC_SAMPLE_PPO2 as a o2 sensor", and "Support multiple o2
sensor values from libdc", i changed that and started to treat
DC_SAMPLE_PPO2 as the o2 sensor values they are.

The po2 variable there was a leftover from when ppo2 and setpoints where
treated the same way, and should be removed.


//Anton - Now with 8 usable fingers


> Signed-off-by: Anton Lundin <glance at acc.umu.se>
> ---
>  libdivecomputer.c | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/libdivecomputer.c b/libdivecomputer.c
> index 3c69900..ef6a9b9 100644
> --- a/libdivecomputer.c
> +++ b/libdivecomputer.c
> @@ -272,7 +272,7 @@ sample_cb(dc_sample_type_t type, dc_sample_value_t value, void *userdata)
>  		break;
>  	case DC_SAMPLE_PPO2:
>  		if (nsensor < 3)
> -			sample->o2sensor[nsensor].mbar = po2 = rint(value.ppo2 * 1000);
> +			sample->o2sensor[nsensor].mbar = rint(value.ppo2 * 1000);
>  		else
>  			report_error("%d is more o2 sensors than we can handle", nsensor);
>  		nsensor++;
> -- 
> 2.1.4

-- 
Anton Lundin	+46702-161604