4.7 - again-help more

[Miika Turkia]

> On 20 Oct 2017, at 6.38, Willem Ferguson <willemferguson at zoology.up.ac.za> wrote:
> 
> 
> 
>> On 20/10/2017 12:22, Dirk Hohndel wrote:
>> 
>> it will show you a curses interface with the cmake variables for this project.
>> Half way down there should be NO_DOCS - what is it set to?
>> How about NO_USERMANUAL ?
>> 
>> If either is ON, move the curser down, press enter to toggle, then 'c' to configure and 'g' to generate.
>> If both are set to OFF, then just press 'q' to quit
>> 
>> /D
> 
> NO_DOCS OFF
> NO_MARBLE OFF
> NO_PRINTING ON
> NO_USERMANUAL              ON
> 
> I use ccmake to change NO_USERMANUAL to OFF. (Had to do this as su
> because of write privileges.)
> 
> Ececuted sudo ccmake again to make sure NO_USERMANUAL is OFF. It was.
> 
> Rebuilt Subsurface (build 1031). Problem not solved but I think it may
> be finger trouble. This probably close to the reason for the problem.

I think you will need to run "cmake .." to get the new config into use.

miika