4.7 - again-help more
Dirk Hohndel
dirk at hohndel.org
Fri Oct 20 04:58:47 PDT 2017
> On Oct 20, 2017, at 7:38 AM, Miika Turkia <miika.turkia at gmail.com> wrote:
>>> On 20/10/2017 12:22, Dirk Hohndel wrote:
>>>
>>> it will show you a curses interface with the cmake variables for this project.
>>> Half way down there should be NO_DOCS - what is it set to?
>>> How about NO_USERMANUAL ?
>>>
>>> If either is ON, move the curser down, press enter to toggle, then 'c' to configure and 'g' to generate.
>>> If both are set to OFF, then just press 'q' to quit
>>>
>>> /D
>>
>> NO_DOCS OFF
>> NO_MARBLE OFF
>> NO_PRINTING ON
>> NO_USERMANUAL ON
>>
>> I use ccmake to change NO_USERMANUAL to OFF. (Had to do this as su
>> because of write privileges.)
>>
>> Ececuted sudo ccmake again to make sure NO_USERMANUAL is OFF. It was.
>>
>> Rebuilt Subsurface (build 1031). Problem not solved but I think it may
>> be finger trouble. This probably close to the reason for the problem.
>
> I think you will need to run "cmake .." to get the new config into use.
'c' & 'g' is supposed to do that.
I think there's a lot more wrong with the build tree. Especially since
it clearly has been built as root at some point. That's why I urged
Willem to move it away and run scripts/build.sh again (as regular user)
in order to get back to a sane state.
/D
More information about the subsurface
mailing list