<div dir="ltr">Hi all,<div><br></div><div>Thanks to all that have contributed to this software that I come to appreciate more and more. After using only the log function for a couple of years, I have recently started to make use of the dive planner and appreciate its benefits as compared to likes of MultiDeco. ie that it recalculates the plan automatically with changes and that it includes the gas planning information in the output in one step. All this makes for very practical "what-if" planning. I have some improvement ideas but will discuss in a later email. For now I wanted to share a bug that some conditions (that I dont fully understand) can cause the gas consumption section of the output to stop being visible and updated.</div><div><br></div><div>I produced a couple of xml with two scenarios that I have found. (I am in Win10 with Subsurface 4.8.5)</div><div><br></div><div>deanm-planner-bug-a.xml</div><div><br></div><div>1. open and then edit the single dive in the planner</div><div>2. note that the plan output includes the gas consumption details (all info below line "<span style="white-space:pre-wrap">Gas consumption (based on SAC 20|17ℓ/min):")</span></div><div><span style="white-space:pre-wrap">3. note that calculations update and change if you adjust for example the runtime to 13min (ie all normal so far)</span></div><div><span style="white-space:pre-wrap">4. delete the 50% deco gas</span></div><div><span style="white-space:pre-wrap">5. note that the plan output no longer includes gas consumption details</span></div><div><span style="white-space:pre-wrap">6. if you save the dive plan the gas consumption info will be there in the notes of the dive plan entry.</span></div><div><span style="white-space:pre-wrap">7. if you reopen in the editor its still not visible there</span></div><div><span style="white-space:pre-wrap">8. edits to runtime etc that would normally trigger a recalculation do not fix it. the gas consumption does not reappear until you add the deco gas back in</span></div><div><span style="white-space:pre-wrap"><br></span></div><div>deanm-planner-bug-b.xml </div><div><br></div><div>1. as before, but note that the gas consumption is missing as soon as you open the dive in the planner.</div><div>2. change the depth from 45m to 50m and the gas consumption now shows up.</div><div>3. change back to 45m and it dissapears again</div><div><br></div><div>hope this is helpful to debug it.</div><div><br></div><div>Regards</div><div><br></div><div>Dean Murray</div><div><br></div><div> <span style="white-space:pre-wrap"><br></span></div><div><span style="white-space:pre-wrap"><br></span></div><div><br></div><div><br></div><div><br></div><div><br></div><div><br></div></div>