[PATCH] Visualisation of individual oxygen sensor data for CCR dives

[Joakim Bygdell]

On 10 May 2017 at 11:33, Anton Lundin <glance at acc.umu.se> wrote:

> On 10 May, 2017 - Jef Driesen wrote:
>

 <snip>

Do we have any data from a Shearwater running as solenoid controller?
>
> Ex. On the JJ-CCR's they use a Shearwater Petrel with sensors which
> controls the o2 solenoid to try to get the o2 sensor values to match
> your configured setpoint.
>
> I have data from a JJ in eCCr mode.
There is no sensor data in that log, only setpoint information at the
start,
when the setpoint changes during the descent and before surfacing.


> That said, I think setpoint values are still interesting to see, to
> validate how well the controller did manage to try to keep the o2 close
> to the setpoint.
>
>
> Attached is the last iteration I did of the sensors patch. It has some
> minor differences from the one you included, but most of them isn't that
> relevant.
>
>
> The only relevant information is that the adc offset value is probably
> in 0.025 mV as unit.
> Thats party based on the information in
> https://www.shearwater.com/wp-content/uploads/2016/07/O2-
> Offsets-Public-Notice-RevA.pdf
>
>
> The only real comment about the code is that I would have liked to see
> the calibration factor kept as a int, and just change the unit factor
> from .00001 to .000022, between the models.
>
>
> //Anton
>
>
> --
> Anton Lundin    +46702-161604
> _______________________________________________
> subsurface mailing list
> subsurface at subsurface-divelog.org
> http://lists.subsurface-divelog.org/cgi-bin/mailman/listinfo/subsurface
>



-- 
// Jocke
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.subsurface-divelog.org/pipermail/subsurface/attachments/20170510/542712ba/attachment.html>