Beta Testing - Dive Planner

[John Smith]

Ive beenplaying the dive planner for CCR dives and have the following comments.
1. The red time/depth cross hair doesn't ever go as far as the zero point on the x axis- Its difficult to tell but it looks like it stays at +10 seconds2. When you have an initial setpoint of say 0.7 in your plan, there is a gradient, from surface to the point that air would give you 0.7, in the PPO2 line, even though that wouldnt be the case in real life on ccr. It also occurs when you put a set point change in, but that would be likely to have a gradient.3.If I click toggle ruler, a red line appears on my PPO2 line but I dont know what it shows (I looked in manual but its not immediately clearof what it shows). However, if I unclick it it doesn't disappear, that is until I click on another toggle such as scale graph. Funnily enough, if I don't unclick toggle ruler and click scale graph, the red line disappears again.4.Finally, I ran a buhlmann 100/100 calculation, i would expect the stops to match up with the tissue limits and calculated ceilings (see attached grab). They seem to be out of sync in this example. This of course may be because I don't know what I'm doing :).
regards
 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.subsurface-divelog.org/pipermail/subsurface/attachments/20150913/fcab7ab6/attachment-0001.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: screen grab.jpg
Type: image/jpeg
Size: 335904 bytes
Desc: not available
URL: <http://lists.subsurface-divelog.org/pipermail/subsurface/attachments/20150913/fcab7ab6/attachment-0001.jpg>